Problem with Lee 230 boolits
Moderators: gds, bakerjw, Dolomite_Supafly
-
- Member
- Posts: 49
- Joined: Sat Oct 12, 2019 8:52 am
Problem with Lee 230 boolits
I'm using Lee 230 mold. Having problem with not seating into chamber and some will get stuck then hard to eject.
- plant.one
- Silent But Deadly
- Posts: 6823
- Joined: Tue Jun 23, 2009 8:31 pm
- Location: Oakland County, MI
Re: Problem with Lee 230 boolits
care to give us a little more info?
oal?
type of brass (headstamp) you're using?
whats the diamater of the bullets out of the mold?
are you running them through a sizer after casting?
anything you can tell us about the process you're using to get from ignots to loaded ammo may be helpful. more information is better than less.
oal?
type of brass (headstamp) you're using?
whats the diamater of the bullets out of the mold?
are you running them through a sizer after casting?
anything you can tell us about the process you're using to get from ignots to loaded ammo may be helpful. more information is better than less.
Reloading info shared is based on experiences w/ my guns. Be safe and work up your loads from published data. Web data may not be accurate/safe.
This disclaimer will self destruct in 10 seconds.
This disclaimer will self destruct in 10 seconds.
Who is online
Users browsing this forum: Bing [Bot] and 82 guests