NOE 311365 - 200 Grain Spire Points......AWESOME

[ThreeHundredTraveler]

What are you guys using for Load Data info with the 311365 NOE mold?

11 grains of 1680
Length - 2.060"- 2.080"

Si will look for some 1680 What Brand??? Another powder possible?
So far all i have is Varget, H4895, IMR4350 WW296

1680 is Accurate powder

Where are you located? I have some 1680 I would trade 2 pounds for some of your WW296

[GrimmLV]

Any more of these in the pipe, Swede?

[scout800a]

You wouldn't still have that top punch for that 311365 would you? I haven't been able to get one. I'd love to buy it.

Thanks

[Overton-AR]

You wouldn't still have that top punch for that 311365 would you? I haven't been able to get one. I'd love to buy it.

Thanks

I'll see if I still have it laying around. I'll PM you if I can find it.

[cboger]

anyone know if these are for sale anywhere already cast? I'd love to try them out but have 0 casting equipment.

[Boosted98gsx]

I need this mould

[wlc]

I've been looking at that mold. Are ya'll loading it as a sub? (I assume yes) What kind of accuracy do you get? Any problems with cycling with a carbine gas system? Thanks!!!

[Overton-AR]

Yes loading it as a sub.....haven't checked it for accuracy. Mostly
cuz I don't care. NOT intended to sound snobby, but I got
into casting for plinking ammo that I could shoot for less than $.09
cents per shot.....including lead, primer and powder.

If its accurate to "minute of a rabbit" @ 50 yards I am happy.....
I am sure its at least that accurate.

As for cycling in carbine gas.....I have no idea. Both my 300BLK
are pistol gas.

[340six]

just looking at books may use use the Varget and WW231 loads safely wit FMJ i have in and in the 265 -168 range They sure look tried and true and am not wanting intervention on the wheel Just want good shotting ammo that is tried and true no problems that is consistent
So starting with 268 A Max WW296 Good primers and brass prep I am on the right road and will do it

[SER]

I went to the web site and it said produce not found. Any plans for another run of this mold?