Would this mold be suitable
Posted: Thu Jan 07, 2021 2:56 pm
for subsonic .300BLK?
https://noebulletmolds.com/site/product ... 222-rn-k3/
Well, while I'm at it another one that I've been looking at...
https://www.mp-molds.com/product/mp-300 ... ltichoice/
Yes, I know about the LEE mold but too many folks have had problems with it throwing too small a bullet diameter and as a new bullet caster I just don't need problems of that sort.
Edit: I'll be sizing my cast bullets with a push through sizer and not lubing but coating with Hi-Tek coating.
https://noebulletmolds.com/site/product ... 222-rn-k3/
Well, while I'm at it another one that I've been looking at...
https://www.mp-molds.com/product/mp-300 ... ltichoice/
Yes, I know about the LEE mold but too many folks have had problems with it throwing too small a bullet diameter and as a new bullet caster I just don't need problems of that sort.
Edit: I'll be sizing my cast bullets with a push through sizer and not lubing but coating with Hi-Tek coating.