Version 4.0 - 265+ grains - testers needed

[Dolomite_Supafly]

We are getting closer and closer to this becoming a reality but I need your help.

I am looking for some more people who are interested in try out these bullets to test feeding in AR15s.

If anyone is interested please contact me. Prefer someone who is experienced at casting as I will send them one of the prototype molds to cast with. When these go into production, which should happen within a month, I will be looking for more people to test the production bullet. Those interested in testing the production bullets do not need experience in casting.

I will submit another post when we are ready for people to test the production bullets.

[xdmalder]

If you want I can test for you. Let me know if there are certain powders you would like if you select me.

[Dolomite_Supafly]

If you want I can test for you. Let me know if there are certain powders you would like if you select me.

You are a few down the line. PM me your address so when it is ready I can get it out.

[Zephhyr]

If you don't have too many people in line already I would like to help test these, I just finished melting down about 200 lbs of coww to get ready for this year's shooting season.

[xdmalder]

Just realized this is a PC only bullet mold and I am not setup for powder coating yet. So I'll have to remove my offer to help. Sorry about that DS.

[dellet]

I've ran enough of these to see the potential in them.

Right now with little effort, minute of clay at 100 yards was very easy to achieve. I won't clutter up the thread but wrote it up here.

viewtopic.php?f=141&t=100346

One thing I have not done and others might try is check feeding from a full magazine. I have had no trouble with as many as 10 in a 20 round Lancer.

I look forward to seeing others results

[kamoto]

I am willing to try either a batch or test mould.

[twcrowe12]

Any update on this?

[Dolomite_Supafly]

They are currently in production and should be available for purchase by July from ACME Bullet Company out of Wisconsin.

[ThreeHundredBlackout]

I can't really help on the casting, but would like to shoot some to test for you, i have a decent selection of sub powders and primers to chose from for loads. I have an 8" 1:7 barrel.