I am looking for a used Dillon trimmer with the 300 BO die.
PM me with what ya have, and price shipped to 75154
WTB: Dillon 1200 or 1500 with 300 BO trim die
Moderators: gds, bakerjw, renegade, tba02
-
- Member
- Posts: 32
- Joined: Mon Mar 19, 2012 10:25 pm
WTB: Dillon 1200 or 1500 with 300 BO trim die
Accuracy is not a gift. A gift is something you don't have to earn.
www.P1ZK.com
www.P1ZK.com
- Netpackrat
- Silent But Deadly
- Posts: 661
- Joined: Mon Oct 26, 2015 2:06 am
Re: WTB: Dillon 1200 or 1500 with 300 BO trim die
If you haven't found a Dillon trimmer yet, FFB is supposed to have more of their Honey Badger trim adapters in stock this week. By the time you get the adapter, router, bit (I am using a 3/8 carbide end mill), and vacuum shroud it ends up costing about the same as a Dillon, but I found it to be a good option with Dillon so backed up. Using a steel die from Whidden; if I ever wear it out I will look at replacing with Dillon's carbide die.
https://fastandfriendlybrass.com/shop/
https://fastandfriendlybrass.com/shop/
-
- Member
- Posts: 32
- Joined: Mon Mar 19, 2012 10:25 pm
Re: WTB: Dillon 1200 or 1500 with 300 BO trim die
I actually will be using this in a RCBS single stage press. I just want to be able to trim brass quick.
I will look into the trimmer.
I will look into the trimmer.
Accuracy is not a gift. A gift is something you don't have to earn.
www.P1ZK.com
www.P1ZK.com
- Netpackrat
- Silent But Deadly
- Posts: 661
- Joined: Mon Oct 26, 2015 2:06 am
Re: WTB: Dillon 1200 or 1500 with 300 BO trim die
You may run into issues fitting the vacuum shroud to evacuate chips on the single stage press. On the Dillon presses you have to use a special reduced thickness toolhead to power trim 300 Blackout and still get the vacuum shroud to fit. This is specific to the short length of the Blackout cartridge; longer cartridges won't have the same issue since the trim die will be longer.
Who is online
Users browsing this forum: No registered users and 66 guests