I purchased the 16.1" CMMG multi-role profile barrel. Vendor sent the CMMG medium taper contour barrel. I sent it back, waiting on correct barrel.
Problem: The spec on the barrel 5/8"-24 tpi. I ordered the Daniel Defense extended flash hider, spec stated 5/8"-24 tpi, but it wasn't even close to fitting. Packaging on the DDFH stated 5/8"-24 tpi, but the inside dimension measured 1/2". The barrel measured 5/8".
I think the item in the DD packaging was incorrect, had to send it back. I'm do not plan on ordering another one.
Question: Has anyone had any luck with the DDFH on the CMMG barrel (5/8-24 tpi)?
Question: Any recommendations on 5/8"-24 tpi flash hider/compensator/muzzle brake that will fit the CMMG MR barrel with the same spec?
(I'm tired of spending money to ship products back to vendors! It just increases the cost of my build.)
Compensator/Muzzle Brake/Flash Hider Recommendations
Moderators: gds, bakerjw, renegade
Re: Compensator/Muzzle Brake/Flash Hider Recommendations
I use a PWS compensator. Comes in a 556 & 308.
Also comes with spacers. To fit right.
Costs under $100.
Keeps barrel centered on target.
Also comes with spacers. To fit right.
Costs under $100.
Keeps barrel centered on target.
Re: Compensator/Muzzle Brake/Flash Hider Recommendations
Thanks I'll check them out.
Who is online
Users browsing this forum: No registered users and 27 guests