Accuracy problems with suppressor

Moderators:gds, bakerjw, renegade

New Member
Joined:Thu Nov 28, 2019 11:34 am
Re: Accuracy problems with suppressor

Post by Buckhunterhite » Thu Oct 15, 2020 4:53 pm

It is definitely accuracy issue. With out suppressor 3 shot groups are 1/2 or so at 50 yards, With suppressor 12 - 15 inch groups. I talked to shop where I got it they said need a h3 buffer. I switched it out and no difference

BulletFlight for Android
User avatar
Silent But Deadly
Joined:Fri Nov 30, 2012 1:25 pm

Re: Accuracy problems with suppressor

Post by dellet » Thu Oct 15, 2020 11:06 pm

Either an alignment problem of the suppressor on the barrel, or inside the suppressor. Most likely a baffle strike. Holes in the target are most likely not round.
300 Blackout, not just for sub-sonics.

Joined:Wed Dec 25, 2013 2:59 am

Re: Accuracy problems with suppressor

Post by silverhawk500 » Sat Nov 14, 2020 3:40 pm

As stated above, this has to be an alignment issue. The buffer is not going to cause this level of change in POI, nor will the gas pressure. Both of these could affect POI but in a precision rifle where your measuring1/16 of an inch. Have you checked the target to see if you are getting a round hole,or oblong. Did you by any chance weigh the can before shooting it? If so you could check weight to see how much it has increased. Also did you check the can while you were firing? I have had some QD cans loosen after 2-3 shots and direct attach after as few as 5 shots. I have had a Liberty Torch loosen on an M-16, now can has 2 holes in the end!! I shoot 300 BO and 308 subs and never had POI change more than 1/2-3/4" with can versus no can, with either bolt or semi auto rifles. I would try it on some other barrel, since it is either loose, or the barrel threading is off- As a side note I would not suggest putting it on a AK pattern rifle, before you check the threads. Be SAfe,

New Member
Joined:Wed Jan 15, 2020 1:16 pm


Post by AlexaGuit » Wed Jun 29, 2022 11:02 pm

Best accuracy should be with the hop off inside 80ft.

Consistency is what you need.
Honestly for what you are doing the Beretta PX4 storm pellet gun is probably a better fit.


Динозавр - это тот же петух, только гребень на всю спину и яйца побольше

Post Reply