5 gallon bucket with 4 gallons of water.
Plastic paint, I used 2 colors, green and tan.
Some kind of stick.
Wire to hand your part,
and last but not least you part.
Spray the paint, into the center of the water, first one color then the 2nd color.
I went with 3 cycles of color.
So I sprayed 1, 2, 1, 2, 1, 2 all pointed at the center of the bucket.
You end up with rings on paint, mix a bit with the stick.
Now dip you part into the water till it is all the way under.
DO NOT PULL IT OUT YET
Let the paint on the water gel, takes about a min or so, take the
stick and get the paint off the water, it will clump to the stick.
NOW lift out the part, this is what you get.
The paint I used will clean off with paint thinner.
