Anyone make BUIS for .300AAC with 16” barrel

Moderators: gds, bakerjw, renegade

Post Reply
Hajji
New Member
Posts: 6
Joined: Thu Jun 16, 2022 9:52 pm

Anyone make BUIS for .300AAC with 16” barrel

Post by Hajji »

I shoot 195 -240 grain subsonic handloads in my 16 inch Blackout. The BUIS will need to be regulated for the different trajectory than seen is using a supersonic round. I cannot lower my front sight post further, and the rear sight has no elevation capability.
Thanks!
Hajji
GeronPG
Member
Posts: 27
Joined: Wed Nov 25, 2015 11:18 am

Re: Anyone make BUIS for .300AAC with 16” barrel

Post by GeronPG »

Subsonics are going to shoot lower than supersonics. If you have the standard front sight atop the gas block, then it sounds like your rear sight is too short. I think a lot of companies make BUIS's, some are made to work with the standard front sight. Most are adjustable.
If you can post a picture it will help
30plinker
Member
Posts: 30
Joined: Sun Apr 10, 2022 11:32 am

Re: Anyone make BUIS for .300AAC with 16” barrel

Post by 30plinker »

Rail height vs. Gas block height may make a big enough difference for you

Otherwise I'd look at either replacement front pin that you can file down to shorten (and still have enough for a proper sight picture) or a replacement rear apeture w/ no hole or minimal hole that you can drill off-center and raised.
Britbike2001
New Member
Posts: 2
Joined: Fri Jan 08, 2021 10:12 pm

Re: Anyone make BUIS for .300AAC with 16” barrel

Post by Britbike2001 »

I have the same set up and found the Ultradyne C2 works.

Its all aluminum and stainless steel, American made and well done.

You should check that out
Hajji
New Member
Posts: 6
Joined: Thu Jun 16, 2022 9:52 pm

Re: Anyone make BUIS for .300AAC with 16” barrel

Post by Hajji »

Thanks for the name of the sights!
blaster
Silent But Deadly
Posts: 780
Joined: Thu Apr 01, 2010 10:18 am
Location: Fla. Keys

Re: Anyone make BUIS for .300AAC with 16” barrel

Post by blaster »

I started putting off set BUIS on my scoped AR 15s. they are really convenient and easy to use. for my reflex sighted ARs I prefer co-witnessing BUIS.
peace through superior firepower
Hajji
New Member
Posts: 6
Joined: Thu Jun 16, 2022 9:52 pm

Re: Anyone make BUIS for .300AAC with 16” barrel

Post by Hajji »

Troy sights worked just fine. Thanks to everyone that responded.
Hajji
Post Reply

Who is online

Users browsing this forum: No registered users and 21 guests