300BlkTalk

Hello, I am new to 300 Blk and searching for a good cutoff jig. I tried a squirrel daddy jig and that did not workout well and the owner was not much help either. When I used the reloadimizer link I saw on this forum it only takes me to Amazon that does not show any Reloadimizer products. I hope to reach Andy or anyone else that can get me connected to Reloadimizer product sales.
Thank you.

I use the jig from ZEP reloading products. I have made hundreds...many hundreds of cut off .223 into 300 BLK. Scored a few barrels full of a commercial reloading company's reject ammo. Pull the bullet, note the powder charges used with each bullet type, create 300 BLK cases with damaged .223 case mouth brass. Note: This took a loooonnnnggg time one winter and then some. Also managed to salvage 2500+ good primers.

Rgr wrote: ↑Sun Dec 05, 2021 9:39 pm Hello, I am new to 300 Blk and searching for a good cutoff jig. I tried a squirrel daddy jig and that did not workout well and the owner was not much help either. When I used the reloadimizer link I saw on this forum it only takes me to Amazon that does not show any Reloadimizer products. I hope to reach Andy or anyone else that can get me connected to Reloadimizer product sales.
Thank you.

His account is no longer on ebay, so not sure how to get ahold of him. I too use the ZEP jig, for the 300BLK and the 277WLV, it has just enough adjustment to do both.

Very helpful, thank you to both of you.

I'm late to the party here, but just as an fyi, the Reloadimizer company was dissolved in 2019, so, unlikely that you'll find one of those jigs for sale (and I'm not giving up mine).