Page 1 of 1
Problem with Lee 230 boolits
Posted: Wed Sep 02, 2020 8:43 pm
by dieselherb
I'm using Lee 230 mold. Having problem with not seating into chamber and some will get stuck then hard to eject.
Re: Problem with Lee 230 boolits
Posted: Thu Sep 03, 2020 12:27 pm
by plant.one
care to give us a little more info?
oal?
type of brass (headstamp) you're using?
whats the diamater of the bullets out of the mold?
are you running them through a sizer after casting?
anything you can tell us about the process you're using to get from ignots to loaded ammo may be helpful. more information is better than less.