I've been exploring the web for info on cutting 223 brass to make .300blk and I found minimum measurements anywhere form 1.360" to 1.368". So, what's a good starting point?
Also, is it important to anneal the brass after re-forming? No one mentions it but it seems to me it might be necessary since that portion of the .223 case would probably not have been annealed before. There's a lot of work involved in cutting, trimming and resizing, I'd hate to do all that and have them split after only one or two reloadings.
R.
Cutting .223 brass?
Moderators: gds, bakerjw, renegade
-
- New Member
- Posts: 3
- Joined: Wed Nov 28, 2018 12:12 pm
- Location: Ellenboro, NC
Cutting .223 brass?
Rusty Shackelford "Bounty Hunter"
- SwampDog_13
- Silent But Deadly
- Posts: 542
- Joined: Wed Jan 13, 2016 2:15 pm
- Location: NC swamp
Re: Cutting .223 brass?
I would recommend getting a jig and then cutting down your .223/5.56 brass to right behind the shoulder or the trim to length for blackout(1.358-1.368"), nothing needs to be exact here it'll just change how much final trimming you have to do. Remember when you reform the brass into blackout it will grow and then need to be trimmed down to your desired trim to length.
I don't make my own blackout brass and some more knowledgeable than I may disagree but I wouldn't anneal until after fireforming the brass just to save a step. It certainly wouldn't hurt anything if you annealed right out of the gate though.
I don't make my own blackout brass and some more knowledgeable than I may disagree but I wouldn't anneal until after fireforming the brass just to save a step. It certainly wouldn't hurt anything if you annealed right out of the gate though.
Re: Cutting .223 brass?
I don't anneal them. I don't have an annealing setup, so It's easier to just make new brass.
Never had a split neck on a 300blk.
Never had a split neck on a 300blk.
Re: Cutting .223 brass?
I cut all of mine to 1.365 and then when I size them they grow about .010. I then final trim to 1.360 and they are good to go. I haven’t anealed any brass yet, but I haven’t had problems either.
Who is online
Users browsing this forum: No registered users and 37 guests