Hello,
Does anyone know how to removal the quad rail on the 8" 300 BLK, LO-PRO. I see there are 6 screws and it appears that you remove those and the rail will slide right off. Am I missing anything?
8" 300 BLK, LO-PRO rail removal
Moderators: gds, bakerjw, renegade
Re: 8" 300 BLK, LO-PRO rail removal
Correct. The handguard will come off after the six screws are removed.
Todd
Re: 8" 300 BLK, LO-PRO rail removal
Man those suckers must be machined tight. I have removed them and the rail will not budge. Guess I will try again this evening.
Re: 8" 300 BLK, LO-PRO rail removal
Use a plastic punch or plastic faced hammer and give it a few taps on the back of the rail.
Don't try to twist it until the pin at the top between the upper and rail is clear.
Don't try to twist it until the pin at the top between the upper and rail is clear.
Todd
Re: 8" 300 BLK, LO-PRO rail removal
Thanks Todd! That did the trick a light tap with a rubber hammer on the rail allowed it to lightly be removed.
Who is online
Users browsing this forum: No registered users and 24 guests