Sig M400 pistol lower
Sig 11.5" upper
JP Silent Capture buffer setup with stock spring
JP trigger kit
Omega suppressor with .30 end cap
Federal factory 5.56 55gn FMJ
Runs like a striped a$$ed ape, with or without suppressor, BUT with Omega attached, no BHO.?
Any ideas ?
No bolt hold open with Omega
Moderators: gds, bakerjw, renegade
No bolt hold open with Omega
Cheech, my best friend of 16 years, RIP.
Never trouble trouble till trouble troubles you.
Never trouble trouble till trouble troubles you.
Re: No bolt hold open with Omega
You broke the mag catch when you installed the supppresor
or you've got gas
or you've got gas
300 Blackout, not just for sub-sonics.
Re: No bolt hold open with Omega
Could be cycling too fast, mag follower may not be able to keep up.
Re: No bolt hold open with Omega
My money is on this. 2 options put in a heavier spring or tungsten weights on the JP SCS or add adjustable gas block. I would go the gas block route if it were me.Tom12.7 wrote:Could be cycling too fast, mag follower may not be able to keep up.
Re: No bolt hold open with Omega
I vote adjustable gas block as well. Most .223.5.56 shorties running a can need them.
R
R
Re: No bolt hold open with Omega
What's the buffer weight?
Re: No bolt hold open with Omega
What direction does the brass eject, both suppressed and unsuppressed (i.e. 1:00, 3:00, etc.)?
Re: No bolt hold open with Omega
With deer season I haven't had a chance to revisit this setup. The buffer is an JP SCS. I have no answer as to where the brass lands.... Yet.
I plan to do some more firing of this setup in the very near future, and will supply some more answers.
Sorry, and thanks for replies.
I plan to do some more firing of this setup in the very near future, and will supply some more answers.
Sorry, and thanks for replies.
Cheech, my best friend of 16 years, RIP.
Never trouble trouble till trouble troubles you.
Never trouble trouble till trouble troubles you.
Re: No bolt hold open with Omega
Both my 8 inch blackout and 10 inch 5.56 run beautifully with a VLTOR A5 receiver extension an A5h3 buffer both suppressed and without. No need for gas blocks to keep fiddling with
NRA Chief Range Safety Officer
NRA pistol, rifle, shotgun, Refuse to be a Victim
NRA Home Firearms Safety, Personal Protection in the Home
Full time instructor with Florida Firearms Training
NRA pistol, rifle, shotgun, Refuse to be a Victim
NRA Home Firearms Safety, Personal Protection in the Home
Full time instructor with Florida Firearms Training
-
- Silent But Deadly
- Posts: 267
- Joined: Sun Apr 06, 2014 10:30 pm
Re: No bolt hold open with Omega
Actually, JP recommends a LIGTHER spring (white). They say that the bolt velocity can be high enough that the latch doesnt have a chance to engage before the BCG returns to battery. This is exacerbated if you're using something like the Magpul BAD lever, or another device which adds mass to the bolt catch.
I'm having the same issue with my 8.2" Noveske 300blk; it wont lock back with my N6 attached (dunno about unsuppressed, never run it that way). I just installed the white spring. Hopefully that'll fix it...
I'm having the same issue with my 8.2" Noveske 300blk; it wont lock back with my N6 attached (dunno about unsuppressed, never run it that way). I just installed the white spring. Hopefully that'll fix it...
Who is online
Users browsing this forum: No registered users and 12 guests