If you take the magazine apart and place it on a rubber mat to prevent it from sliding around you can take the ribs down the proper amount through the whole magazine length using a flat joinery float (looks like a metal file cranked up to 11). It only takes a few strokes because these things are very aggressive at removing material.Dolomite_Supafly wrote:And I have yet to figure out a way to remove the entire rib, at most I can get about 1.5" in so when you load a magazine all the way up you get binding again or a reduced capacity.
New bullet design with a waist for Magpul magazines
Moderators: gds, bakerjw, Dolomite_Supafly
Re: New bullet design with a waist for Magpul magazines
Re: New bullet design with a waist for Magpul magazines
if he needs beta testers I'm injreinke wrote: ↑Sun Aug 23, 2015 11:29 am Robert's patent application finally hit the USPTO web site:
http://pdfaiw.uspto.gov/.aiw?Docid=2015 ... 6769CEC40F
Re: New bullet design with a waist for Magpul magazines
This appears to be a recently revived necro thread. Did this bullet or a mold for it ever make it into production?
Who is online
Users browsing this forum: No registered users and 35 guests