Problem with Lee 230 boolits

Moderators: gds, bakerjw, Dolomite_Supafly

Post Reply
dieselherb
Member
Posts: 48
Joined: Sat Oct 12, 2019 8:52 am

Problem with Lee 230 boolits

Post by dieselherb »

I'm using Lee 230 mold. Having problem with not seating into chamber and some will get stuck then hard to eject.
User avatar
plant.one
Silent But Deadly
Posts: 6823
Joined: Tue Jun 23, 2009 8:31 pm
Location: Oakland County, MI

Re: Problem with Lee 230 boolits

Post by plant.one »

care to give us a little more info?

oal?

type of brass (headstamp) you're using?

whats the diamater of the bullets out of the mold?

are you running them through a sizer after casting?



anything you can tell us about the process you're using to get from ignots to loaded ammo may be helpful. more information is better than less.
Reloading info shared is based on experiences w/ my guns. Be safe and work up your loads from published data. Web data may not be accurate/safe.
This disclaimer will self destruct in 10 seconds.
Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests