I have a Lee 230 mold coming but wanted to hear from others on different bullet weights available. I will be using shooting them in a 10.5 AR based rifle with pistol length gas system. I will be powder coating all of the bullets. Plus I use suppressors on most of my firearms.
I would like to find one around 208-220 grains. Will be using for plinking but would like the bullet to be accurate at 100-150 yards.
Sub sonic bullet molds
Moderators: gds, bakerjw, Dolomite_Supafly
- cwlongshot
- Silent But Deadly
- Posts: 1128
- Joined: Sat Oct 18, 2014 7:53 pm
- Location: Connecticut
Re: Sub sonic bullet molds
I tried that LEE mold. Was PIA to cast with and never could get to where I thought I should be able to
Gave up on it last year.
Hope it’s working for you
CW
Gave up on it last year.
Hope it’s working for you
CW
A Bolt, Single Shot and a few M$Rs
Join me on RUMBLE! Https://rumble.com/user/cwlongshot
https://youtube.com/channel/UCBOIIvlk30qD5a7xVLfmyfw
I PROUDLY SUPPORT LAW ENFORCEMENT & OUR TROOPS
Join me on RUMBLE! Https://rumble.com/user/cwlongshot
https://youtube.com/channel/UCBOIIvlk30qD5a7xVLfmyfw
I PROUDLY SUPPORT LAW ENFORCEMENT & OUR TROOPS
Re: Sub sonic bullet molds
I have the Lee mold. The bullets drop undersized. I used powder coat on them and barely had any resistance to a .310 sizing bushing from NOE.
I also picked up the MP 235 gr and the MP 311-410 clone.
I also picked up the MP 235 gr and the MP 311-410 clone.
Re: Sub sonic bullet molds
I also have the Lee mold, drops typically at about 225+ gr. Accuracy sucked until I started coating them. I'm gonna ream the bases to remove the stupid boat tail and extend the length and diameter of the the first 1/2 inch to .310/.311. I run the coated projos through a .310 sizer. Gonna use some Eastwood Ford Blue and shuck the HF red, that stuff works...but goes on too thick in my experience.
- cwlongshot
- Silent But Deadly
- Posts: 1128
- Joined: Sat Oct 18, 2014 7:53 pm
- Location: Connecticut
Re: Sub sonic bullet molds
I picked hp a new to Me Mold two months or so back. Its a steel Lyman 311284 HP. CASTS A 210g deep HP bullet with a .298 nose. PC brings that up to .303/304 Still fine for my guns.
I shoot is sub and super with good accuracy using 1680.
I cast is in WW air cooled and 20:1 allow when Im loading subs where expansion is wanted.
CW
I shoot is sub and super with good accuracy using 1680.
I cast is in WW air cooled and 20:1 allow when Im loading subs where expansion is wanted.
CW
A Bolt, Single Shot and a few M$Rs
Join me on RUMBLE! Https://rumble.com/user/cwlongshot
https://youtube.com/channel/UCBOIIvlk30qD5a7xVLfmyfw
I PROUDLY SUPPORT LAW ENFORCEMENT & OUR TROOPS
Join me on RUMBLE! Https://rumble.com/user/cwlongshot
https://youtube.com/channel/UCBOIIvlk30qD5a7xVLfmyfw
I PROUDLY SUPPORT LAW ENFORCEMENT & OUR TROOPS
Who is online
Users browsing this forum: No registered users and 30 guests