**THE ORIGINAL FASTEST BLACKOUT JIG ** IN STOCK****

[vz58]

Still the best made, fastest, most stable, safest jig around.

Thanks

[vz58]

The holiday weekend orders put us about 1-2 days behind on orders. We should be back to next morning shipping by thursday. Will update the site too as we are low on inventory especially after a lot of orders this last week.

Yall are great, thanks for the word of mouth you are obviously getting out.

[vz58]

Back on next day shipping schedule!

[vz58]

Back on next day shipping schedule!

[vz58]

Bump

[dddoo7]

Well...I have been using this jig for several years. I have somewhere around 50,000 to 60,000 pieces of brass run through it. With practice I got to where I could do just over 2,000 pieces/hr with it. It is still going strong...but I have retired it because I have upgraded to a much more expensive and faster homemade method. This single jig has worn out MANY harbor freight saws...and the jig is still going strong. Don't hesitate to buy one.

I can't get a picture to post...but here it is if you want to see it

http://i.imgur.com/pgPK1P7.jpg

[vz58]

Well...I have been using this jig for several years. I have somewhere around 50,000 to 60,000 pieces of brass run through it. With practice I got to where I could do just over 2,000 pieces/hr with it. It is still going strong...but I have retired it because I have upgraded to a much more expensive and faster homemade method. This single jig has worn out MANY harbor freight saws...and the jig is still going strong. Don't hesitate to buy one.

I can't get a picture to post...but here it is if you want to see it

http://i.imgur.com/pgPK1P7.jpg

Thank you, we have jigs with over 100,000 cases through them. Those wear points on your early jig have been addresses with a longer, modified feed ramp. I would suspect a significantly longer life span than 100,000 conversions now.



Jigs in stock!


We also have all kinds of easy ID magazine bands!

[VENT625]

vz.....I've moved and actually lost mine!! Need a replacement!!!

[vz58]

You LOST yours? How do you lose it?

[VENT625]

You LOST yours? How do you lose it?

No clue.....lost my chops saw it was attached to as well. Have another saw but need another jig!!