Compensator/Muzzle Brake/Flash Hider Recommendations

Moderators: gds, bakerjw, renegade

Post Reply
BIZZARO
New Member
Posts: 4
Joined: Fri May 30, 2014 3:51 pm

Compensator/Muzzle Brake/Flash Hider Recommendations

Post by BIZZARO »

I purchased the 16.1" CMMG multi-role profile barrel. Vendor sent the CMMG medium taper contour barrel. I sent it back, waiting on correct barrel.

Problem: The spec on the barrel 5/8"-24 tpi. I ordered the Daniel Defense extended flash hider, spec stated 5/8"-24 tpi, but it wasn't even close to fitting. Packaging on the DDFH stated 5/8"-24 tpi, but the inside dimension measured 1/2". The barrel measured 5/8".
I think the item in the DD packaging was incorrect, had to send it back. I'm do not plan on ordering another one.

Question: Has anyone had any luck with the DDFH on the CMMG barrel (5/8-24 tpi)?

Question: Any recommendations on 5/8"-24 tpi flash hider/compensator/muzzle brake that will fit the CMMG MR barrel with the same spec?

(I'm tired of spending money to ship products back to vendors! It just increases the cost of my build.)
Tacshot
Member
Posts: 44
Joined: Fri Jun 01, 2012 7:47 pm
Location: central florida

Re: Compensator/Muzzle Brake/Flash Hider Recommendations

Post by Tacshot »

I use a PWS compensator. Comes in a 556 & 308.
Also comes with spacers. To fit right.
Costs under $100.
Keeps barrel centered on target.
BIZZARO
New Member
Posts: 4
Joined: Fri May 30, 2014 3:51 pm

Re: Compensator/Muzzle Brake/Flash Hider Recommendations

Post by BIZZARO »

Thanks I'll check them out.
Post Reply

Who is online

Users browsing this forum: No registered users and 22 guests