Hello I have seen a few other posts on this issue but not much resolution. I have keyholing issues with my 6 inch 300 bo suppressed with 3 types of subsonic ammo. I used an alignment rod to check and it looks perfect. I switched the suppressor to an 8.3 inch from the same mfg and it does not keyhole. This is the second barrel I have tried thinking the barrel was the issue. Anyone else been through this?
Thanks
6 inch 300 black out keyholing
Moderators: gds, bakerjw, renegade
Re: 6 inch 300 black out keyholing
What
Twist rate,
Bullet,
velocity
Twist rate,
Bullet,
velocity
300 Blackout, not just for sub-sonics.
Re: 6 inch 300 black out keyholing
Its the BA 1 in 7 twist 6 inch 300 bo barrel. I've shot s and b 200 gr, remington 220 grain and 190 gr sub x hand loaded that is 1100 fps out of the 8.3 inch barrel. Not sure about the other speeds due to not owning a chrono myself. Since this is my second one of these barrels I'm back to the suppressor. I haven't shot it without the suppressor due to having semi close neighbors but did use it on the 8.3 inch with round holes. Thanks
- plant.one
- Silent But Deadly
- Posts: 6823
- Joined: Tue Jun 23, 2009 8:31 pm
- Location: Oakland County, MI
Re: 6 inch 300 black out keyholing
take a test shot without the suppressor.
i'm not suggesting dumping a whole mag.. but a shot or three shouldnt make a difference. at least then you'll know
are you using a QD system for the can or direct thread?
i'm not suggesting dumping a whole mag.. but a shot or three shouldnt make a difference. at least then you'll know
are you using a QD system for the can or direct thread?
Reloading info shared is based on experiences w/ my guns. Be safe and work up your loads from published data. Web data may not be accurate/safe.
This disclaimer will self destruct in 10 seconds.
This disclaimer will self destruct in 10 seconds.
Who is online
Users browsing this forum: No registered users and 29 guests