Just a thought
Moderators: gds, bakerjw, renegade, bamachem
Just a thought
Has any one ever thought of cramming a 9mm bullet into a 5.56 brass? I've seen 9mm uppers and 9mm ammo brass is very close to 5.56 brass in diamitore? Like a said just a thought.
Re: Just a thought. Up date
Just tried cramming a 9mm DPX into a cut case. And it did go in but the case would need to be full length formed up to match the diamitore of the 9mm. It is possible. I'm thinking 9mm supermax!
Re: Just a thought
NO.. I would keep it just a thought.
Re: Just a thought
Please in lighten me? Why not?
Re: Just a thought
Has it been done?
-
- Silent Operator
- Posts: 89
- Joined: Mon May 21, 2012 2:08 pm
Re: Just a thought
Why would you want to do that with 9mm once fired brass so cheap?
Re: Just a thought
A similar cartridge was called the " 9mm Winchester Magnum". It is now obsolete.Ed Songer wrote:Has it been done?
It fired an 115g bullet at about 1450fps. (A 300 Blackout fires a 115g bullet at 2000+ fps.)
Comparing the cartridges, the 5.56 case is smaller at both the head and shoulder so it would not be practical to use it with a 9mm bullet.
However, you could probably neck up the 6.8mm Rem SPC to hold a 9mm bullet.
M.
THANKS! TO THE AMERICAN VOTERS FOR DEFEATING CLINTON AND MAKING TRUMP OUR PRESIDENT!
Re: Just a thought
I think a 9mmBR or 9mm/.308 Win. would be kinda cool.
Re: Just a thought
Thanks 80hp! Like I said it was just a thought! And I knew that I would get some good answers:) I was just siting here with both cartridges and looking at them.... And it clicked is this possible? Thank you
Re: Just a thought
.35 Remington...2bad4u2 wrote:I think a 9mmBR or 9mm/.308 Win. would be kinda cool.
Who is online
Users browsing this forum: No registered users and 178 guests