Finally, the perfect (compromise) 300 BLK AR
Moderators: gds, bakerjw, renegade
Re: Finally, the perfect (compromise) 300 BLK AR
Found cfe pistol & 150gr cast cycles fine, just over super.
Re: Finally, the perfect (compromise) 300 BLK AR
How did you drill and tap the carrier? I was going to do this same thing but everyone said it’s too hard and would break the tap.
-
- Silent But Deadly
- Posts: 349
- Joined: Thu Dec 22, 2011 9:03 pm
Re: Finally, the perfect (compromise) 300 BLK AR
I have 7.5", 10.5" and 12" AR uppers. I like the 10.5" the best. It seems to be the best size length to do everything without being overly long when suppressed.
- bangbangping
- Silent But Deadly
- Posts: 2695
- Joined: Sun Sep 15, 2013 6:34 pm
- Location: Texas Gulf Coast
Re: Finally, the perfect (compromise) 300 BLK AR
Carbide end mill to poke the hole. Just a regular tap, but I wasn't sure if wasn't going to break. Went very slow, backing up frequently.
Re: Finally, the perfect (compromise) 300 BLK AR
Thanks. I have a milling machine setup and ready to go but wasn’t sure about the tapbangbangping wrote: ↑Sun Dec 29, 2019 8:22 pmCarbide end mill to poke the hole. Just a regular tap, but I wasn't sure if wasn't going to break. Went very slow, backing up frequently.
Who is online
Users browsing this forum: No registered users and 24 guests