Custom adjustable gas block
Moderators: gds, bakerjw, renegade
Custom adjustable gas block
I couldn't find an adjustable gas block that I liked so I decided to build one. It will have three detented settings; Off, full flow for subs, and limited flow for supers. The block is constructed of stainless steel as will be most other parts. I will post more pics as I progress on the machining.
Re: Custom adjustable gas block
Sorry, new member and can't figure out how to post pics
Re: Custom adjustable gas block
Careful you do not infringe on patents for the Govenah or micro Govenah if you intend to sell them.
Re: Custom adjustable gas block
No intent to sell, building for personal use
Re: Custom adjustable gas block
Please keep the photos coming. I'm contemplating doing the same.
Re: Custom adjustable gas block
Drilling the valve stem in a collet block so holes are perfectly perpendicular to one another. Large hole is for subs that delivers full gas with a 0.109 hole. The smaller hole is for supers with a beginning ID of 0.055. If that small of a port doesn't cycle the supers I will drill out larger in small increments until it cycles. In between these will be the off position with all positions controlled by a detent.
Re: Custom adjustable gas block
Gas tube in, but will need to be bent downwards to account for the added height the valve stem adds.
Re: Custom adjustable gas block
Front view showing detent hole. This will have a detent pin in, then spring, then capped with a set screw.
Re: Custom adjustable gas block
Starting to slim it down and cut off excess stock
Who is online
Users browsing this forum: No registered users and 134 guests