8.5" barrel overall length?
Moderators: gds, bakerjw, renegade
Re: 8.5" barrel overall length?
Ok, so stick a spare bolt in there, make sure it's rotated in, measure from the crown to the face?
I do not reply to posts with horrific grammar errors.
I do not reply to posts concerning the case mouth dent.
I do not reply to posts concerning the case mouth dent.
Re: 8.5" barrel overall length?
Yes. Barrel length is measured from the bolt face to the end of the barrel. Put the bolt in, put a rod in the barrel and mark it, measure the rod. If it is 10.2" and you want 8.2" then you know that you need to cut off 2".
Re: 8.5" barrel overall length?
Ok, thanks all, I'll update when the barrel comes Tuesday. Sure would be easier if liberty would cut and crown, but the barrel was on sale, so I'll break pretty even.
I do not reply to posts with horrific grammar errors.
I do not reply to posts concerning the case mouth dent.
I do not reply to posts concerning the case mouth dent.
Re: 8.5" barrel overall length?
I got the barrel, stuck an old bolt in it, into battery, then inserted a cleaning rod. Set it all up on end so gravity would hold it together, marked the rod, and got a measurement of just under 10 3/16" from bolt face to crown. My thoughts are to have my smith cut off 1 11/16", so it will fall somewhere between 8.2 and 8.5" for Liberty. I'm going to double check with them tomorrow.
I do not reply to posts with horrific grammar errors.
I do not reply to posts concerning the case mouth dent.
I do not reply to posts concerning the case mouth dent.
Re: 8.5" barrel overall length?
So what does it cost to get them to build an integrally suppressed upper?
- Dolomite_Supafly
- Silent But Deadly
- Posts: 3017
- Joined: Fri Oct 30, 2009 7:03 am
- Location: East Tennessee
- Contact:
Re: 8.5" barrel overall length?
Not that much actually.Toxarch wrote:So what does it cost to get them to build an integrally suppressed upper?
http://libertycans.net/leonidas/
WWW.thegunmilitia.com
Come join the militia!
Come join the militia!
Re: 8.5" barrel overall length?
Pretty surprising price for the level of performance, less than my Tirant. Of course I have to supply an upper, so it'll be pricey in the end, but still less than you'd expect.
I do not reply to posts with horrific grammar errors.
I do not reply to posts concerning the case mouth dent.
I do not reply to posts concerning the case mouth dent.
Re: 8.5" barrel overall length?
$1707 for the upper alone. Not bad considering an AAC 9" upper costs close to $1000 and the AAC SDN6 costs $850. Can't swap the can to another gun would be the only major down side.
Re: 8.5" barrel overall length?
Don't need two stamps either.
I do not reply to posts with horrific grammar errors.
I do not reply to posts concerning the case mouth dent.
I do not reply to posts concerning the case mouth dent.
Re: 8.5" barrel overall length?
Really? Is that because the OAL is over 16 so it's not considered a SBR?
Who is online
Users browsing this forum: Google [Bot] and 143 guests