HD Weapon light? 600 lumens or 1000?
Posted: Wed Mar 21, 2018 9:19 pm
Well, I've gone out and zeroed my red dot at 50 yards now (see other post, thanks by the way!) and now I've got a white light attached to it...and it's ready to rotate into my HD closet. I've attached some pics of it's HD setup that it will be wearing most of the time. I'll be using the 110 gr BlackTips in it, and it has the Sig Sauer Romeo5 XDR (has either a single 2moa DOT or a 2moa dot with the 65moa circle around it) with MOTAC (motion activated ON and OFF so it can just stay ON all the time) and it will also be wearing my Omega.
I was in the market for a good weapon light for it and I picked up two Surefire flashlights...the P2X Fury Tactical and a P3X Fury Tactical. I figured the TLR2 wasn't quite enough light for a long gun and got a great deal on both of these lights. They both have the single lumen output and the tailcaps are momentary or clicky on. Exactly what I was looking for in weapon lights. The only difference between the two (other than the lumens...600 vs 1000) is 1 1/4" in length, and that once takes 2 CR123's and the other takes 3 CR123's. The 1000 lumen P3X, has a slightly longer run time according to the specs (2.25 hours versus 1.5 hours), but I don't know if that is full lumen output or now. Weight is negligible and with the suppressor on the light pattern will be the same also. I was going to put the larger one on my Mossberg500 but after getting it all mounted up I might like the longer one on the 300blk...plus, the 300blk has more range, so the 1000 lumens might come in handier on that rifle than on the shotgun.
Opinions? Which light would you put on the 300blk and why? And which one would look better? I attached pictures with and without the suppressor and the short one is even with the flash hider when the suppressor is off and the long one would stick out 1 1/4" inches further. It will never be fired without the suppressor on really so I don't care about soot or anything like that (I do have that issue with my primary arms flashlight on my 5.56...it wears a tactical rubber when I go to the range with it so I don't have to clean it off when I'm done...plus I know it's not going to get any STD's ). It's no biggie and I'm trying not to overthink this, but just curious what you guys would do if you had both lights and the 300blkSBR and a Mossberg500 to mount them on.
Thanks in advance!
By the way...both of these lights are freaking bright!
Edit: After posting the pics I noticed that I actually got one of my other HD weapons in the pic...my yellow lab's two front paws!
Randy
I was in the market for a good weapon light for it and I picked up two Surefire flashlights...the P2X Fury Tactical and a P3X Fury Tactical. I figured the TLR2 wasn't quite enough light for a long gun and got a great deal on both of these lights. They both have the single lumen output and the tailcaps are momentary or clicky on. Exactly what I was looking for in weapon lights. The only difference between the two (other than the lumens...600 vs 1000) is 1 1/4" in length, and that once takes 2 CR123's and the other takes 3 CR123's. The 1000 lumen P3X, has a slightly longer run time according to the specs (2.25 hours versus 1.5 hours), but I don't know if that is full lumen output or now. Weight is negligible and with the suppressor on the light pattern will be the same also. I was going to put the larger one on my Mossberg500 but after getting it all mounted up I might like the longer one on the 300blk...plus, the 300blk has more range, so the 1000 lumens might come in handier on that rifle than on the shotgun.
Opinions? Which light would you put on the 300blk and why? And which one would look better? I attached pictures with and without the suppressor and the short one is even with the flash hider when the suppressor is off and the long one would stick out 1 1/4" inches further. It will never be fired without the suppressor on really so I don't care about soot or anything like that (I do have that issue with my primary arms flashlight on my 5.56...it wears a tactical rubber when I go to the range with it so I don't have to clean it off when I'm done...plus I know it's not going to get any STD's ). It's no biggie and I'm trying not to overthink this, but just curious what you guys would do if you had both lights and the 300blkSBR and a Mossberg500 to mount them on.
Thanks in advance!
By the way...both of these lights are freaking bright!
Edit: After posting the pics I noticed that I actually got one of my other HD weapons in the pic...my yellow lab's two front paws!
Randy