300BlkTalk

Concerning getting a stuck round out of the chamber, you can try using a screwdriver of the proper size between the bolt carrier and the frame. Take the upper off if possible and look down int the front area at the bottom of the bolt carrier. There will be a slight gap that the screwdriver will fit...

I only put about maybe 10 rounds though my gun before I realized there were primer blowouts. The very next round caused the jam. I quit using them. I read the warnings but even still I wouldn’t expect them to be this bad. One would expect they are just covering their butt legally if something happe...

ponzer04 wrote: ↑Tue Nov 13, 2018 11:51 pm I got a sneak peek pre-assembly

This really makes me what to do a fully white AR

I have seen charges as low as 1gn of powder and as high as 18gns. :shock: That's nuts. What is the headstamp of the brass? Can you measure the neck diameter of a loaded round? Yeah I was really surprised to see as far of deviation as I did. The brass is random 223 and 556 stamped converted cases. G...

I only put about maybe 10 rounds though my gun before I realized there were primer blowouts. The very next round caused the jam. I quit using them. I read the warnings but even still I wouldn’t expect them to be this bad. One would expect they are just covering their butt legally if something happen...

Hey all, I am new to the forum but wanted to get this information out. Do NOT buy FEDARM bulk ammo. The ammo has several DANGEROUS problems. The charge weight varies by + or - 10 gns of powder. I had to weigh each one (500) to separate out the deviant loads. I did this after getting very common prim...