300BlkTalk

i haven't put it on paper yet, but ya, its 1 10. not sure what the results will be. i assume if it develops problems red x will replace it if they change their barrels to a faster twist.

i was shootin 200s though.

it was pretty quick. i got they feeling they are assembled when ya order. it was less than a week though. very fast i would say. fit and finish was fine, no blemishes etc. rocked out to the range yesterday, EXCELLENT performance! no malfunctions, locked bolt open even with a rifle buffer/tube. i was...

i love standardized thread patterns, no reason to break the mold folks. i am pretty psyched about this as well. aint a big bull pup fan, but this might convince me. especially if ya can just buy a new 556 barrel as well. as one guy in the comments section said on the firearms blog, why do i need a S...

i just bought one. remember, the DSA upper was gonna be 330WITHOUT -quadrail -muzzle brake -fluting -SS -flattop FSB -bcg/ch these are inexpensive because they do most everything in house. thats what they said on the phone anyways. yes, i drank the coolaid, no they not paying me. and ya, the 1 10 is...

heres my retro build, gonna put an a1 stock on it with matchin grey anoddizin eventually...

these? i been wanting to load some as well, but didnt have data...

think its possible? or maybe if you dont use a spitzer bullet? perhaps a round nose? i think it could be alot of fun. been wantin a m1 carbine, but i dont want to chase down another caliber....

good point, AR!

i want to start casting some bullets, but i dont want my initial investment to be too high. so i am goin with lee. just need some input as far as which gr mold is the best and with what style of meplat (nose?).....lemme heeeeeer some opinions...

make sure you clean your dies out or you gonna have some rust!!!

this is a weird forum. doesnt seem to be alot going on.

your thoughts are appreciated, welcome to the forum!