300BlkTalk

How are these at reducing the cycling noise while suppressed?

I buy them directly from the factory as they are on my way to a buddy's house I visit a couple times a year. They have always charged the same amount as what they have listed online.

Very nice! I took a trail in my Armada up to a peak (7500 ft) about 1/2 hour from my house. I am going to run it in my DRZ soon I decided. Thanks for sharing!

Look into powder coating your cast bullets,,it basically stops all lead fouling. The few I have shot so far leave a cleaner bore than jacketed bullets! +1 I have run about 150 powder coated boolits that are 50/50 ww/pure water dropped. Zero leading when sized after the powder coat to .308 and up to...

A few months ago I traded a 16" Carbine bbl for a 16" Pistol CMMG WASP bbl. I took it to a local smith who cut it down to about 9" and re-threaded it for about $125. A short time after that my tax stamp finally arrived and I was able to put the can on and take her out. Bad news. I'm p...

Thanks for posting. I will give this a try this weekend. Thus far I have been dealing with the garbage left at the base of the bullet by overspray and lots of wasted powder.

my mold works great and I powder coat using a jig I made so the boolits are nose down and all but the tip gets PC and no problems loading or shooting them. I use 9.0 gr. lilgun in factory hornady cases with wolf srm primers. I water drop my boolits after casting. straight WW Would you mind posting ...

Quick update. I got out over the weekend and put a through rounds through with the modded CH. It was WAY better than stock! I was doing 6-7 shots rapid fire and had no vision or breathing problems like before. I can't say whether or not the drilled port helped, but I am happy with the results!

one fix.. if you can find one... get a ops-4 side charging upper receiver.. i have a couple of them and made a couple for a friend too.. no gas in the face EVER! subs or supers... https://www.youtube.com/watch?v=2UehOw94yc0 That was my original plan, but gave up looking. Maybe when things calm down...

I contacted LEE and they said to put the die in a vice and hump down on it to fully seat the pins, so in the vice it went and now there is no more gap. I will be powder coating these cast rounds(and drilling the nose) I sure wish they made this mold with hollow point pins, drilling each round is a ...