300BlkTalk

Here’s what I did: Google “fire sleeve” in your local area. I bought 3 FEET for ~$12, in the correct diameter for my can. It is rated up to 500 degrees F continuous and even higher for short periods. There are other types that take more heat. Cut it to the proper length with household scissors. Then...

Here’s what I did: Google “fire sleeve” in your local area. I bought 3 FEET for ~$12, in the correct diameter for my can. It is rated up to 500 degrees F continuous and even higher for short periods. There are other types that take more heat. Cut it to the proper length with household scissors. Then...

Also, since adding a suppressor doesn't resolve the problem by increasing the back pressure within your gas system, you may have an alignment issue with your gas block and gas port. Check to make sure the hole in the gas block is centered over your barrel's gas port. If it is an adjustable gas block...

The Law Tactical Folding Stock Adapter adds a bolt carrier extension to your bolt carrier, which adds weight to your bolt assembly. I suspect that the added weight is the cause of your issues. You may be able to correct the issue by using a lighter-weight buffer spring.

I use mine to keep from burning my hands or my gear/bag if I accidentally touch the suppressor to any of those things. I made a relatively inexpensive cover by purchasing two feet of aviation fuel line fire sleeve for like $12, cut it to length, and then bought a cover from Rifles Only. It's good to...

I have a gen 3 FSA and love it! Like they said above, it adds a little weight and about 1"-1.5" length of pull. I use it in conjunction with a LWRC UCIW Ultra Compact Stock, which is about 1" shorter than a normal stock, so the length of pull is about standard. With this setup I have ...

Here's the method that works for me. I remove the decapping pin from my 300BLK resizing die. I then resize my clean .223/5.56 brass, which necks down the case body to the proper size for 300BLK. I then cut off the excess brass and then trim to length using my Worlds's Finest Trimmer. I then put the ...

Roverhound I have come to the same conclusion. Too bad RCBS doesn't make an add-on micrometer seating stem for their dies.

Thank you for your reply!

Good morning! Do any of you know if it's possible to add a micrometer seating stem to an RCBS 300BLK seating die? I have the RCBS 300BLK SB FL die set, & am looking for a more precise way to seat bullets.

Here's a 10.5" BA barrel with an AAC Brakeout 2.0 installed under a 9" BCM Keymod Alpha rail, with an AAC 7.62 SD attached:

http://rs1283.pbsrc.com/albums/a552/dbl ... 0&fit=clip

Not sure how to get the image to appear...