300BlkTalk

I shoot all of my new loads at 5 feet without the can to make sure I am getting nice round holes.

as soon as i have time to figure out how many cases I have i am going to mail them to him. I only have a bolt gun so I think 2,000 will last me and my kids a lifetime.

I have 1000 that I paid to have done and I dont remembering it being too expensive. I have an annealer but I don't have the time to do it.

Thanks

Do you have grumpa's contact info?

Try 6.9-7.0 grains of aa#5 with a 208 grain amax. Pretty damn quiet. You might have to play with the charge a little to get 1040 fps out of your rifle. My bolt action has a 9 inch barrel and a 12 inch supressor. 7.0 grains gets me 1040. Cutting the barrel down from 16 did not change the velocity muc...

Any recommendations for somebody that can trim/chamfer and anneal several hundred pieces of brass made from lc 5.56 cases?

Thanks

Has anybody got any experience with these? I need a good bullet for my 300 whisper but I don't know whether to get the soft point or the open tip 220 grain.

I know they are expensive but if they work 100 would last me several years.

Thank you very much.

Can I replace the extractor in my 223 bolt with another remington extractor to get better results?

I built my gun off of a 223 remington 700 action.

Thanks

2bad4u2 wrote:If you don't want to modify the bolt for a Sako extractor, maybe you could use the one Remington uses for .17 Rem. FB based rifles.

Do you know the part #?